6
« on: April 13, 2013, 12:28:20 PM »
Hi Everyone, I have found the solution to my problem and so post it here just in case someone else has similar.
When I first got interested in a plugin for the Huanyang vfd I first downloaded the other plugin written by Matty Zee. His plugin manual instructs to "Firstly, open Mach3 ‘Ports & Pins’ config dialog. On the ‘Spindle Setup’ ensure the ‘Disable Spindle Relays’ checkbox is unchecked. This is required to enable the plugin to control the spindle."
When realising that his plugin would not work for my setup I then used this new plugin but didn't realise that I needed to have the ‘Disable Spindle Relays’ checkbox, checked.
Once I had checked the box the spindle motor now works as expected with m03 and m04 doing the foward and reverse and m05 stopping the motor.
Hope this helps.