Hello Guest it is March 29, 2024, 06:24:55 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - descore

Pages: 1
1
General Mach Discussion / Re: Pacific Scientific Drives
« on: May 07, 2006, 03:22:35 PM »
I connected the step- and dir- to the common terminal on my breakout board and the step+ and dir+ to the step and dir terminals. Works great!

2
General Mach Discussion / Pacific Scientific Drives
« on: May 02, 2006, 11:35:37 AM »
I am building a new cnc router using pacific scientific drives and motors. I'm using a Sound Logic breakout board to connect everything. My P70360 drives have 4 pins for step and direction. Step +, Step -, Dir + and Dir -. Mach3 and the breakout board only have one step and one direction input. Any input on how to wire this would be appreciated.

Pages: 1