Messages

1

General Mach Discussion / MACH 3 losing XYZ

« on: October 04, 2007, 02:23:06 PM »

Having just updated to Mach 3 after purchasing a new pc running XP pro, we have discovered Mach3 likes to lose its x/y/z settings during a program run... it will be going along then all of a sudden it just loses it (always of course to a detrimental effect) this has caused our overages on the milling job to reach unacceptable levels. is there any suggestions as to why this would be or should we be investigating finding new controller software?