Guest
Show Posts
1
General Mach Discussion / Mach3 Turning Spindle
« on: July 20, 2022, 12:56:58 AM »
Hi,
I am using Mach3 turn since a long time but now facing a problem i have to cut Multi start(multi face) Threads but from same Z axis position for that i have to go for Ac Servo for spindle. i have installed Ac Servo on my spindle but now did'nt get any Gcode for Indexing my and run in continue in same Program so any one could give any solution.
any G-code for Spindle positioning.
Best Regards
Mughal
I am using Mach3 turn since a long time but now facing a problem i have to cut Multi start(multi face) Threads but from same Z axis position for that i have to go for Ac Servo for spindle. i have installed Ac Servo on my spindle but now did'nt get any Gcode for Indexing my and run in continue in same Program so any one could give any solution.
any G-code for Spindle positioning.
Best Regards
Mughal