Hello Guest it is March 29, 2024, 02:51:23 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - James Hui

Pages: 1
1
Hi, Good Day
I have a problem need help. I generated a G-Code ( file extension . nc) from Fusion 360 and would load it to my MACH3. But I got the following message on the MACH3 G-code display window "The Postprocessor is a sample for MACH3. For more information on how to update your post processor to review http://knowledge.sutodesk.com/community/article/3   . But I cannot find this article.

Many Thanks in advance ,

James

Pages: 1