Guest
Show Posts
1
General Mach Discussion / interesting homing issue
« on: December 23, 2021, 12:02:35 PM »
Hello guys and Merry Xmass for all from SOCAL
I swapped out a generic (joke) cnc motion card to a ZK Motion card for many reason more output, more input up to 6 axis and more robust. As you can see on the video after hitting home switch Z axis travel about 1.5-2 inches down and then creeping back up to home, takes 1 min on 20%, then the Y axis doing the same thing but it travels +5 inches then its creeping back to the homing switch, I did not find anything in the Mach3 to control these issue anyone know where the problem lies?
https://youtu.be/e3f84tTlt1o
I swapped out a generic (joke) cnc motion card to a ZK Motion card for many reason more output, more input up to 6 axis and more robust. As you can see on the video after hitting home switch Z axis travel about 1.5-2 inches down and then creeping back up to home, takes 1 min on 20%, then the Y axis doing the same thing but it travels +5 inches then its creeping back to the homing switch, I did not find anything in the Mach3 to control these issue anyone know where the problem lies?
https://youtu.be/e3f84tTlt1o