1
Mach4 General Discussion / Re: New people welcome !! Come in here and introduce your self!
« on: October 08, 2021, 02:50:19 PM »
I am new and have an issue i need help with. This morning i was running along fine until i started a new sheet and at the beginning of the cycle, when it got to the tool change line...M06, i got a message. At this point, I get an error message that says "Wait Brush Position Limit Signal" and 3 or 4 seconds later it changes the error message to "EStop Button Pressed". I have turned everything off and restarted which usually cures any issue.... but i cannot move forward now. Please advise. THANKS!!!!