Messages

1

SmoothStepper USB / Re: X-AXIS DRIFT ONLY WHEN PROGRAM IS RUNNING

« on: January 17, 2022, 03:34:07 PM »

I have the exact problem the calibration is spot on but when I run a program it drifts on the y axis after an hour cutting it is about 10mm off. X axis is spot on.I have a dual drive y axis and i have not been able to get rid of the missing steps and i now going to load windows and mach3 again to see if it is still the same.

regards Gerry

2

General Mach Discussion / mach 3 set up

« on: October 11, 2021, 01:11:38 AM »

I have a two tress 4 axis 100mhz board and it will not cut a circle  or let you jog two axis at the same time is there a setting in the program for this as each of my motor controllers has its own power supply? running nema34 with 48v 8amp power supply.