Hello Guest it is March 28, 2024, 01:58:41 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - icy498

Pages: 1
1
General Mach Discussion / Missing Steps maybe?
« on: October 04, 2021, 02:32:11 PM »
I am not sure if this is a mach or a machine issue. I am running a carve that I saved into 2 files (1 tool each) and I zero everything properly with my probe. When I go to run the 2nd tool all seems to start well and then it jumps...please see enclosed pic

Pages: 1