Hello Guest it is April 25, 2024, 06:37:27 AM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - UncleDonut

Pages: 1
1
SmoothStepper USB / Re: WOW
« on: March 20, 2008, 06:01:19 PM »
Care to elaborate?   Even just a little?  What do you know?

-Dave

2
General Mach Discussion / Re: PC hardware for mach
« on: January 29, 2008, 12:35:34 AM »
Thanks, I'll give it a shot.

-Dave

3
General Mach Discussion / Re: PC hardware for mach
« on: January 28, 2008, 12:45:12 PM »
Quote from: DennisCNC on January 25, 2008, 02:45:12 PM
Make sure to use a video card and not on board video.

Does this hold true for the newer faster computers?


Pages: 1