1
General Mach Discussion / Re: Unable to open ProbeDiag.dat Error=11
« on: June 15, 2021, 07:01:17 PM »
The thing that solved it for me was closing the Notepad window that was opened by clicking "Edit G-code" from a previous Mach3 instance.
Not certain, but I'm suggesting this as a potential cause of the issue:
- "Edit G-code" in Mach3 --> opened Notepad window
- Closed Mach3 without closing Notepad window.
- Opened Mach3 again. Error because Notepad window is still open.
Not certain, but I'm suggesting this as a potential cause of the issue:
- "Edit G-code" in Mach3 --> opened Notepad window
- Closed Mach3 without closing Notepad window.
- Opened Mach3 again. Error because Notepad window is still open.