Messages

1

PoKeys / Re: Two buttons doing same thing, possible?

« on: January 03, 2014, 06:41:18 PM »

They are just plain arcade buttons with cherry brand micro switches, and they are momentary.

I think its how I had it set, however will check in the morning, thanks again!

- Russ

2

PoKeys / Re: Two buttons doing same thing, possible?

« on: January 03, 2014, 05:03:38 PM »

jogging is not related to kbd48cnc, i just have 6 arcade buttons on my panel i made that are connected to pokeys directly, and would like to use two for x jogging, two for y and two for z.

3

PoKeys / Re: Two buttons doing same thing, possible?

« on: January 02, 2014, 03:35:52 PM »

Thanks! Seems to work good now with both buttons operating correctly. Have not tested Single Block yet however.

Got another question also, probably wrong section for it, but its same thing, i have buttons connected thru pokeys56u, and i would like to be able to jog with them same way you can with arrow keys/pg up/down, but only way it works right now if you press button the table moves by itself until you press button again, which is not very safe, i want  it to move only when button is pressed. Any idea what # button to use for these?

Thanks,
Russ

4

PoKeys / Re: Two buttons doing same thing, possible?

« on: December 24, 2013, 11:33:55 AM »

Alex,

I tried your solution, honestly didn't get anywhere(most likely because missed something), but what I did encounter was my Single Block stopped working, any ideas?

Thanks,
Russ

5

PoKeys / Re: Two buttons doing same thing, possible?

« on: December 16, 2013, 12:02:26 PM »

Ok.., just tried making a brain, and I clueless at this, any way you could walk me thru what I need to do?

Screenshot attached, is this what I need to do?

Thanks for the help,

6

PoKeys / Re: Two buttons doing same thing, possible?

« on: December 16, 2013, 11:15:51 AM »

Hi,
link the  kbd48cnc buttons to a user led instead to cycle start / feed hold
lets say when you press cycle start ULED 2000 turned on
the same thing with your external button, lets say ULED 2001

now create a brain thats  doing a cycle start when one of or both went on.

Or just wire the external button to the same pin to kbd48cnc button ( if that is possible )

just a thought

alex

ha! if I would only be smart enough to do that, will give it a try later today when i'm in the shop. Tho I do have an question, would this introduce any kind of lag/delay?

Thanks,
Russ

7

PoKeys / Re: Two buttons doing same thing, possible?

« on: December 15, 2013, 09:45:13 PM »

Any resolutions for this? Really need to get this working.

Thanks,

8

PoKeys / Not able to get PoKeys56U to work with Gecko G320X

« on: November 20, 2013, 01:17:53 AM »

I have been trying to use pokeys56U to output step/dir to my gecko drives to control servo, following the instruction I still dont get anywhere, has anyone had luck doing this, and if so, any pointers?

Using Pokeys software 3.0.65 with Pulse engine enabled.

Thanks,
Russ

9

PoKeys / Re: Two buttons doing same thing, possible?

« on: October 20, 2012, 08:53:34 AM »

Finally got around to testing the set up, still not working, with invert checkbox checked only the external button is working

10

PoKeys / Re: Two buttons doing same thing, possible?

« on: September 28, 2012, 10:46:28 PM »

Thanks, that would be really nice