Hello Guest it is April 14, 2021, 01:22:54 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - dandreger

Pages: 1
1
General Mach Discussion / Re: external under pule frequency
« on: December 31, 2020, 11:11:11 AM »
         
         the card has an eagle on it and its red the only name I could find is bitsensor.com
         The driver that I download to mach3 is RnRmotion
         I also used the 5 pin choices on one axis to try to get my limit switch to work

2
General Mach Discussion / external under pule frequency
« on: December 30, 2020, 04:54:17 PM »
         
             what am I missing? I have mach3 usb bob .The board lights up motors work.My limit switches are not working and my emergency switch is also
            not working.I have power at the board and there is power at the limit switch.when I look at my diagnostics page the word external show up under
             the pulse frequency is this normal

Pages: 1