Messages

1

General Mach Discussion / Re: Mach3 with STB5100

« on: January 06, 2021, 06:56:46 AM »

Hi, thanks for the reply. The driver I'm using the TB6600 4 axis driver. The stepper motors are working fine. It's the communication from Mach3 to the VFD that I haven't figured out yet. Difficult to find more documentation. I was looking to make sure I had the right pin number because it's connected to FWD and AVI. I'll go through the supplied manual again.

2

General Mach Discussion / Re: Mach3 with STB5100

« on: January 05, 2021, 12:56:56 PM »

Setting up with the STB5100 also. I should of done a bit more research on the boards. So far I can ref home, jog around. Loaded a couple of G-Codes, not convinced it's doing the full job. Spindle isn't set up yet. I can run it manually but finding it difficult to find information on how to run it from MACH3. I dont think I have the right 'pins' entered. Did anybody figure out this step yet?  Thanks