Hello Guest it is March 28, 2024, 11:02:10 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Letectables

Pages: 1
1
General Mach Discussion / Stepper motor calculated steps have changed.
« on: December 13, 2020, 04:11:15 PM »
The driver board switches are set to 1/16  and should result with X axis 320 steps, but in auto Settings it has set the steps to 160 This suddenly happened after re down loading Mach3 ( had been fine for 7 years) This has resulted in less detailed machining. I have now replaced the computer running the same Windows 7, this was done by an IT guy I know and issue has remained the same Has anyone any idea how to fix this?

Pages: 1