1
Mach4 General Discussion / 4th (A) axis DRO not showing correct value
« on: April 07, 2022, 02:52:34 PM »
Hi all,
I've got my 4th axis setup for testing. After getting my servo drive and mach4 motor 3 setup, I am able to move the axis very accurately. However, the DRO is way off (e.g. moving from 0 to 65 degrees moves the axis to 65 degrees, but the DRO reads approximately 2.0791). I can't find any other settings in Mach that would account for this weird scaling. The DRO is using the 'A Multiple Pos' setting. Any ideas?
-Mark
I've got my 4th axis setup for testing. After getting my servo drive and mach4 motor 3 setup, I am able to move the axis very accurately. However, the DRO is way off (e.g. moving from 0 to 65 degrees moves the axis to 65 degrees, but the DRO reads approximately 2.0791). I can't find any other settings in Mach that would account for this weird scaling. The DRO is using the 'A Multiple Pos' setting. Any ideas?
-Mark