1
General Mach Discussion / Re: Cycle start and spindle start
« on: November 18, 2020, 05:30:05 AM »
Thanks Tweakie
I assume VB is a virtual button. So could I copy the code for the existing cycle start button, then add M3 to start the spindle and G04 for a delay to allow the spindle to speed up.
Haven’t yet got a clue on how. More learning on top of everything else.
Cheers
Kk
I assume VB is a virtual button. So could I copy the code for the existing cycle start button, then add M3 to start the spindle and G04 for a delay to allow the spindle to speed up.
Haven’t yet got a clue on how. More learning on top of everything else.
Cheers
Kk