1
Mach4 General Discussion / Re: [ESS] Z axis issues
« on: November 12, 2020, 06:28:36 PM »
Did you ever find a resolution for this I have the same issue
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
So I figured out my problem and wanted to post the solution for anyone who runs into similar problems.
When downloading the support files for TMC 3in1 you need to install the m2020 macro from warp 9’s page. MAKE SURE THE OTHER M2020 IS DELETED!!!!!!
This was a very large pain in my rear that I caused myself by following the steps to fast. It also took way to long to figure out.
Hopefully my mistakes help someone in the future. Thank you all for you assistance