Messages

1

FAQs / Re: Homing and Limit Configuration

« on: January 18, 2021, 10:41:08 PM »

Hello Bill,

Thank you this information it is very useful, I try to implement it with my configuration.

2

FAQs / Re: Homing and Limit Configuration

« on: January 18, 2021, 08:39:39 PM »

Bill,

Thank you for your reply and link.  I fiddles with the settings and got everything working with trial and error.

3

FAQs / Re: Homing and Limit Configuration

« on: October 13, 2020, 08:16:40 AM »

    Thank you for the help.

4

FAQs / Homing and Limit Configuration

« on: October 13, 2020, 05:26:04 AM »

I have a Sherline 5410 (metric) milling machine running through a cheap Chinese breakout board by Bitsensor.com model BSMCEO4U-PP.  I have all the axes and pin setup correcting where I can jog back and forth through Mach3.  However; my problem is setting up my homing/limit configuration.  I have looked at many online tutorials and some of them can be a little confusing to a person unifiliar to Mach3.  Dose anyone know the proper setup for homing/limit configuration for a Sherline Mill or should I say does anyone know of a good tutorial step-by-step guide for a newbie to Mach3?