Hello Guest it is March 29, 2024, 09:42:51 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Iftikhar Amin

Pages: 1
1
General Mach Discussion / Re: 5 axis
« on: October 05, 2020, 01:31:31 AM »
thanks a lot.
this post will help me.

2
General Mach Discussion / Re: 5 axis
« on: October 04, 2020, 03:21:57 AM »
thanks for the advise.
have you tried fusion 360 for mach3 5axis.
please tell me how i can configure mach3 PP

3
General Mach Discussion / Re: 5 axis
« on: October 01, 2020, 03:37:58 AM »
i have seen you link regarding 5 axis when opening the link i can not find where to download.
have you tried that link.
please check and tell me.
thanks,

4
General Mach Discussion / Re: 5 axis
« on: September 30, 2020, 08:03:06 AM »
First i will try to edit this file and see if it works.
what cam software if suitable for 5 axis?
 

5
General Mach Discussion / Re: 5 axis
« on: September 30, 2020, 07:37:35 AM »
ok.
it is generated by the rhinocam.
how i can figure it out.
any suggestion?

6
General Mach Discussion / Re: 5 axis
« on: September 30, 2020, 04:52:48 AM »
Hi,
thanks for your response.
attached pics is for your reference.
i will send you full g codes if you required.
thanks,

7
General Mach Discussion / 5 axis
« on: September 30, 2020, 01:55:21 AM »
Hi group members,
i am encountering an error message when i am loading my 5 axis tooth path.  ( No digits found where real number should beline 6).
i am using rhinocam to generate the g code.
please help.
thanks

Pages: 1