Hello Guest it is March 29, 2024, 11:03:50 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - tonydude919

Pages: 1
1
General Mach Discussion / Re: Problem with hooking up touchplate
« on: September 28, 2020, 10:05:08 AM »
Everything is working fine now. I had to pull up the jumper on 2 and 3.

2
General Mach Discussion / Re: Problem with hooking up touchplate
« on: September 10, 2020, 08:45:46 PM »
Thank you, I will try that tomorrow.

3
General Mach Discussion / Problem with hooking up touchplate
« on: September 03, 2020, 06:05:34 PM »
Hope you can help me out, my friend has a g540 board and I tried to setup the touch plate exactly like in the videos, hooked up to pin 15 which was available and done the rest with the script etc.The problem is the light is on all the time, even with the ground not connected, do you think something is grounding it out somehow in the control box? I even redid it 5 times. I removed the wire from pin 15, so somebody can look at board.

Pages: 1