Hello Guest it is March 29, 2024, 01:30:49 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - pbw

Pages: 1
1
General Mach Discussion / Mach 3 Z Axis move during cutting with Plasma
« on: September 03, 2020, 11:23:19 PM »
I'm running Mach3 in plasma mode. All is well except I can't make a Z axis move while cutting.
I have THC UP and THC Down Emulated with the keyboard, Mach3 is "seeing" that the keys are pressed but doesn't respond.
Is there another setting or settings that have to be changed?
Thanks

Pages: 1