Messages

1

General Mach Discussion / Re: Converting from Centroid m39 to mach3

« on: March 14, 2011, 10:28:32 AM »

Just spoke to our machine guy and he said we were analog +-10v. Also he thought that mach 3 did not support servo  yet. Does anyone know if that is true?

Thanks,

Rick

2

General Mach Discussion / Re: Converting from Centroid m39 to mach3

« on: March 10, 2011, 03:26:12 PM »

I am not sure but will find out a.s.a.p.

Thanks

3

General Mach Discussion / Converting from Centroid m39 to mach3

« on: March 10, 2011, 02:01:42 PM »

Hello,

Does anyone know roughly what would be involved in switching from a Centroid m39 control system to mach3 in terms of boards etc?

Thanks for any help.

Rick

4

General Mach Discussion / barcode reader

« on: September 10, 2007, 11:13:27 AM »

Just started looking at mach3 and was wondering how to get a barcode on label to open the corresponding machining file in mach3?