Messages

1

General Mach Discussion / spindle feedback

« on: October 01, 2020, 09:19:54 PM »

Hi,
Can anybody please guide me how to connect the encoder shown in the attachment, to get the spindle r.p.m. in
 mach 3Turn.
Your response is highly appreciated.
Nitin

2

General Mach Discussion / eas-e turn screen set

« on: August 01, 2020, 07:52:07 AM »

Hi friends,
 I am a newcomer to this forum having no knowledge in electronics.
Is there somebody using Eas-e turn screen set likely to solve my minor problem.
I am using a manual chuck for holding the job.
Message box triggers (collet warning - collet open)every time I start the cycle.
Solution for this will be appreciated.
Thanks
Nitin