1
Mach4 General Discussion / Re: Fusion 360 simultaneous machining on the A axis
« on: June 14, 2020, 06:55:19 PM »
double check that fanuc post, guess it's 5axis.
the #8 does work fine with the right setup. (pulley turns over X) your setup turns over Z !!! here a 5 axis post ain't going to complain
Grts,
the #8 does work fine with the right setup. (pulley turns over X) your setup turns over Z !!! here a 5 axis post ain't going to complain
Grts,