1
General Mach Discussion / Re: Help with mach 3, starting cut position
« on: March 08, 2024, 07:36:08 AM »
I put the 0 of the piece on one end in the center, I know that at mach 3 I have to indicate the radius of the piece, but when I go to mach 3 and tell it where the 0 of my piece is, when it starts cutting instead of starting where I gave it 0 it moves to the side and starts and apart from that it starts cutting the piece as if it were placed horizontally, and I have it vertically as you can see in the photo. I'm attaching fusion file to see if you can help me with that.
My big problem here its the starting positing when im gonna cut.
My big problem here its the starting positing when im gonna cut.