1
General Mach Discussion / Re: Mach3 or machine problem?
« on: June 03, 2020, 08:07:06 AM »
Oh ok, I overlooked this in brackets what you've written.
Ok then, I will check our ESS.
I don't want to bother you too much, you've helped enough already, just one more question:
We are not ultra experts here, so I have to ask. ESS should work with any CNC?
I mean, there is nothing special here. Stepper motors and proximity sensors, every machine has them. You just route the inputs/outputs and you are good to go.
Regards,
peri_95
Ok then, I will check our ESS.
I don't want to bother you too much, you've helped enough already, just one more question:
We are not ultra experts here, so I have to ask. ESS should work with any CNC?
I mean, there is nothing special here. Stepper motors and proximity sensors, every machine has them. You just route the inputs/outputs and you are good to go.
Regards,
peri_95