Hello Guest it is May 06, 2021, 03:42:08 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Vatersauto

Pages: 1
1
Mach4 General Discussion / Re: mach4 homing
« on: May 29, 2020, 02:20:08 AM »
OK i under stand now so the RefAllHome is for a place like a spot on my table, well thanks for the information ,but i am now installing limit switch on it this weekend Thanks for your help Craig  8)

2
Mach4 General Discussion / Re: mach4 homing
« on: May 28, 2020, 02:58:00 PM »
So i do have to put  an actual limit switch? i thought you could use soft limits but i guess i was mistaken. where can i get the script if i decide to stay with soft limits? thanks for the help.   




robin

3
Mach4 General Discussion / Re: mach4 homing
« on: May 27, 2020, 11:37:10 PM »
I am not sure you talking about (Depending on what is programed) i am running latest ver of mach4 but its 4.2.0.4300. what i am trying to do is do a homed command , what i have done is setup in soft limit . what i have done is put my axis at my position and hit Reference all axis and it will go to 0.0000 on x x and z with no movement but at 0.0000... then i move my all axis and reboot the mill when then i hit the reference all axis noting happen.. but axis said 0.0000 with no movement .. I have watch some videos with no success.. ya am a 60 year old newbie. please help Thanks   

4
Mach4 General Discussion / mach4 homing
« on: May 27, 2020, 11:09:39 AM »
I am newbie at mach4 I am trying to homed all axis, but i do not see a button for homed, the only button i see is reference all axis (home), but i can inter a g code g28 x0.0 y0.0 and z0.0 it will go homed. please help.. My  Ver 4.2.0.4300 Thanks :o

Pages: 1