Hello Guest it is March 29, 2024, 03:27:24 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - 548cidakota

Pages: 1
1
PoKeys / Re: POKEYS57CNC and Mach4 Homing Switches
« on: May 20, 2020, 04:40:05 PM »
Curious what you found out with your homing issues with your Pokeys57cnc. I am having issues homing mine as well. All my negative limits are seen and functioning, but none of my home/limit switches are not even registering. I have confirmed my wiring multiple times, but still cannot resolve it. In the diagnostics tab, the end limits will appear when activated, but it wont acknowledge my home/limits. Its like they are not even connected. I have tried both the ribbon connector and and the limit screw pin terminals on the board and still nothing.

Any tricks you could give me would be greatly appreciated.

Shane

Pages: 1