1
General Mach Discussion / Re: CNC stalling on long moves
« on: May 20, 2020, 04:11:35 PM »
Conclusion......Lack of proper maintenance
After applying dry lubrication on the 2 rails and lead screws and running it back and forth manually.
Everything is resolved.
Not enough lubrication on our (my) part.
The plastic makes small chips and also a fine dust. Living i the high desert we get big temp swings
30F at night 80+F midday. We hadn't done much running for the past 7 months.
All this just make the Y axis fail.
Up and running now.
Thanks for your support.
After applying dry lubrication on the 2 rails and lead screws and running it back and forth manually.
Everything is resolved.
Not enough lubrication on our (my) part.
The plastic makes small chips and also a fine dust. Living i the high desert we get big temp swings
30F at night 80+F midday. We hadn't done much running for the past 7 months.
All this just make the Y axis fail.
Up and running now.
Thanks for your support.