Hello Guest it is March 28, 2024, 09:06:38 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - routermaker

Pages: 1
1
Great! Thank you so much for the spot-on replies.  I saw the UC300 and thought it looked promising. 

Can anyone outline how the analog input maps to the feed rate?

I want to use the analog input signal as a set-point, i.e. voltage mapped to a given FRO%. 

Are "Brains" and Modbus understandings both necessary components to executing?

Can anyone give me a basic roadmap of what I need to set to learning?

Thank you.

2
Hi Folks,
This is my third Mach3 machine build but I need a slightly out of the ordinary solution.

I want to build a little 2 axis turning machine for wrapping wire on a mandrel at a varied pitch.

I would like to control the feed rate (via FRO%) using a foot pedal.  I found a sewing machine pedal that is a simple potentiometer that uses a 3.5mm headphone jack (max 15V) that I want to use. I suppose could read the voltage via arduino if necessary but then what?

Can anyone suggest the best method for this? For instance is there a analog read capability built in to a basic BOB? 

I want the pedal to go from 0% FRO with no foot and 250% pedal to the metal.

Any help greatly appreciated!!!!

Pages: 1