Hello Guest it is April 14, 2021, 05:27:39 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Gary.S

Pages: 1
1
attached is one G code

2
ok i will try and post the G code if that helps

3
Hi All,

I'm new to the C'N'C and have a system that is using the Mach3 program.
I have a lot of G code programs  but every time i load it up the image in mach3 is off the table at the bottom and you can't see it.
Not sure what i have done or it's something to do with the coding. I have tired many different ones and the same result. Any help would be great.
My father In-law had it working great and it's been handed down to me as he has passed away and i didn't get enough time to learn how to use it before hand.
If you can suggest any courses i could take to help me learn would be a plus.
Thanks again for any help.
Please see attached picture.



Cheers Gary.

Pages: 1