Hello Guest it is March 29, 2024, 03:08:31 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Nic

Pages: 1
1
General Mach Discussion / Encoder setup (feedback in mach3)
« on: April 18, 2020, 08:18:13 AM »
Encoder setup (feedback in mach3)
There is a Chinese servo motor 110ST MO6030.
There is a need to configure the encoder (feedback)
SmoothStepper Controller (Ethernet)
And the interchange board C25-Smooth Stepper LPT Board Rev. 5.
Need help setting up and connecting.

Pages: 1