10
« on: April 02, 2020, 04:20:27 PM »
Hi, as soon as I can, I'll update it to see if it's out there.
Do not buy the encoder because as I already mentioned we have made a retrofit of the lathe. The machine was working, the problem went away and we put this in control.
So we are using the encoder that I already had.
My lathe is a large one, a bench of 2m and a plate of 400mm.
As it is not the update, or that it derives from somewhere, I do not know where to throw it, it took more than 2 years to see if we managed to make the threading work, we asked the cslab and it told us that they would correct the firmware error.
But at the moment nothing, the machine works perfectly less the threading.
From what I see people do thread with mach4.
Thanks for everything, I will update what I said and I'll tell you to see if it works. Thank you