1
General Mach Discussion / Can two different Mach3 profiles open in two different monitors?
« on: November 23, 2021, 02:00:20 PM »
Hi!
I'm planning on using one PC with dual monitor support to control both mill and lathe.
Over Windows 10 (using ESS) is it possible to make one profile of mach3 open in one monitor and another profile to open in the other monitor? Not at the same time, sure.
Thanks!
I'm planning on using one PC with dual monitor support to control both mill and lathe.
Over Windows 10 (using ESS) is it possible to make one profile of mach3 open in one monitor and another profile to open in the other monitor? Not at the same time, sure.
Thanks!