Hello Guest it is October 03, 2023, 07:03:18 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Norman

Pages: 1
General Mach Discussion / Using a PS4 controller with Mach3
« on: February 23, 2020, 02:43:28 PM »
Please be patient, this is my first post.  I'm not new to CNC or to PC's, but I am new to Mach3 and PS$ controllers. I've been watching videos, trying different software and suggestions, all with very limited sucess. My controller responds to some buttons, but never what I want, and changing the settings in JoyPad setup doesn't seem to change much.  Has anyone had any positive results?  I just want to be able to move XYZ with the controller, nothing fancy.

Pages: 1