1
General Mach Discussion / Re: Motor only turns one direction
« on: February 08, 2020, 10:50:24 AM »
@natefoerg,
Thank you for the reply. It turned out I did not have those configured correctly. I went by an incorrect video that had me using +5v for the PUL+ and DIR+ pins with the pulse and direction wires going to the PUL- and DIR- pins. The correct way is to have gnd going to the PUL- and DIR- with the pulse and direction wires going to PUL+ and DIR+.
This is all a big learning curve so thank you again for the help!
Bruce
Thank you for the reply. It turned out I did not have those configured correctly. I went by an incorrect video that had me using +5v for the PUL+ and DIR+ pins with the pulse and direction wires going to the PUL- and DIR- pins. The correct way is to have gnd going to the PUL- and DIR- with the pulse and direction wires going to PUL+ and DIR+.
This is all a big learning curve so thank you again for the help!
Bruce