Messages

1

Mach4 General Discussion / Re: Slave motor not working with primary motor

« on: January 31, 2020, 04:10:39 PM »

Steve, thank you for your help!  Ron

2

Mach4 General Discussion / Re: Mouse Jogs work, but keyboard jogs do not

« on: January 30, 2020, 09:06:11 PM »

Success!
I accidentally left the strange keystrokes in there when I was having issues (before I found out about the keyboard enable button)…
Thanks Steve!

3

Mach4 General Discussion / Re: Mouse Jogs work, but keyboard jogs do not

« on: January 30, 2020, 07:59:38 AM »

Yes, I am having the problem in Mach4.  As I mentioned, I have enabled the Newfangled Solutions Keyboard plugin, and in the jogging tab, I have the keyboard Jog set to ON.  I can jog using the mouse, but not with the keyboard.

Are there any other switches that I need to set to get the keyboard to work?

Thanks,
Ron

4

Mach4 General Discussion / Mouse Jogs work, but keyboard jogs do not

« on: January 29, 2020, 12:11:10 PM »

I have enabled the Newfangled Solutions keyboard enabled, as well as the keyboard jog in the mouse jog window...but I cannot get the keyboard to work...

The keyboard works when I hook my Mach3 machine back up...

I have a Gecko540 with a PMDX-411 smart bob interface...

Your help would be appreciated...
Ron

5

Mach4 General Discussion / Slave motor not working with primary motor

« on: January 29, 2020, 12:04:08 PM »

I have the axis mapping set up like the following:
X(0)  Motor0  Motor3
Y(1)  Motor1
Z(2)  Motor2

However, only Motor0 works when I jog in the X direction
I hooked my Mach3 back up and it works fine??

I am using PMDX-411 Smart Bob interface...

I have other issues, but I will start a new topic...

Thanks,
Ron