1
General Mach Discussion / Re: Red/CAM PDMX 122
« on: January 25, 2020, 08:27:59 PM »
So I ended up just buying a used desktop from a friend for $40, just wanted to get this machine moving without having to wait for online buying etc. So with some time in the ports and pins page I now have all axis moving. Great news! Next up is turning on and off spindle which I am getting no response. In my spindle setup page CW M3 is listed as output #2. In my output signals page I have output #2 enabled and output #2 port # as 2. What do I put for the pin #? Anything else I need to do to enable spindle? What about in the motor outputs page under spindle? Just enable or what step pin # and direction pin # do I use? When I'm in MDI and press the Spindle CW F5 button the bar above does flash yellow until I press that button again.
Any info is greatly appreciated,
Thanks!
Any info is greatly appreciated,
Thanks!