Messages

1

Mach4 General Discussion / Modify Mach4 Wizards?

« on: January 22, 2020, 11:40:04 AM »

Is there any way to modify the canned cycle Wizards in Mach4?
I am working on a Boxford TCL125 that has a tool turret and a rear slant bed.
The existing wizards all put a M03 and a T0101 in the G code.
I need to change those to M04 and Tnnnn if at all possible. M03 is good for drilling but for turning I need M04.

2

Mach4 General Discussion / Re: "Go To WorkZero" doesn't lift up Z axis.

« on: January 20, 2020, 03:43:03 PM »

Has this ever been resolved?
I am getting the same results in my newly installed Mach4 build 3200, GoToWork Zero moves all axis except Z
I tried Mill and Lathe profiles, same results.

3

Mach4 General Discussion / Re: Mach4 Homing doesn't set DRO's to zero

« on: January 16, 2020, 03:48:01 PM »

I don't mean to hijack, but where is this Machine Diagnostics tab located? I dont see it in Mach4 Lathe.