Hello Guest it is August 19, 2022, 04:45:46 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Frederic1231

Pages: 1
1
Mach4 General Discussion / Re: Need the mcTHC.lua file
« on: December 29, 2019, 03:37:30 AM »
Its just a small file from the THC module.
 And many other modules are free to edit like Probing etc.

 And there is probably a error in the file that I need to fix for me.

You get a nice THC screen but you can't edit the function that's not great.


2
Mach4 General Discussion / Need the mcTHC.lua file
« on: December 28, 2019, 02:56:23 PM »
I have a Plasma Probing problem.

I now in the file is the problem.

But it is a luac file and I can't edit it.

I need the source file.

3
Mach4 General Discussion / Re: M3 Probing error THC Pokeys
« on: December 12, 2019, 05:30:42 PM »
My max Probe travel is at 100mm and my min max THC 100 and - 100 it is more then enough.

 I have no soft limits enabled.

The problem only occurs on the m3 Macro not in other Z Probe Funktions.

The I use shielded and grounded wires.

The PoKeys57CNC has some input filtering built in. And I played with the software filtering as well.

4
Mach4 General Discussion / M3 Probing error THC Pokeys
« on: December 11, 2019, 05:21:47 PM »
I have bought Mach 4 last week as an upgrade for Mach3.

I have a Plasma table with PoKeys57CNC and a PlasmaSense THC unit. I am using a Floating Head configuration.

I am using the Plasma Screen and I got the THC working but sometimes while Probing it stops the cycle.

Macro Alarm: 3 The Probe did not strike during our M3 touch move.

But the Probe signal is activ if I look at the diagnostic page.

This problem randomly occurs.

Any clue?

And my value in the dros of the THC settings screen are changing every time I restart Mach 4.



Pages: 1