1
G-Code, CAD, and CAM discussions / Re: sainsmart 3018 MX3 laser does not immediately honour M3/M5
« on: November 10, 2019, 12:23:44 PM »
Hi Lawrence! Did you ever come up with a fix? I have the same mx3 and their 5.5 w laser. I got it set up to have zero lead in or out and close the burn fully without turning off early. But I have not been able to get it to not burn in each start. Lots of research shows its the "spindle spool up" time built into the m03. So did you ever get an m10px to work or swap boards or...? Thanks!
Jason
Jason