Hello Guest it is May 12, 2021, 02:22:20 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - frobi

Pages: 1
1
Mach4 General Discussion / Re: Settings not saving?
« on: January 28, 2020, 05:43:39 AM »
Did you solve your issue? I’m having the same problem

2
Are you using limit switches? if so are the limit switch wires shielded? I had this same problem, replaced the limit switch wires with shielded wires and haven't had the issue since

3
Ok, reinstalling Mach3 fixed the issue.

4
That's just it. It's not backing off at all. When it homes it stays against the switch

5
So where do I set the back off distance to keep my machine from homing on the limit switches under Mach3?

Pages: 1