Messages

1

PoKeys / Re: Setting error inputs

« on: February 17, 2020, 05:50:05 AM »

Hi
I use output 3 for testing.
You have to short error input to the ground (or to 5v, it depends on your driver) and check the red lamp (Output signals, Diagnostics tab). Test error inputs one by one, and if everything works, change from output 3 to reset.

2

PoKeys / Re: Setting error inputs

« on: February 16, 2020, 11:58:07 AM »

I had random errors with my ethernet. The cause was conflicts with internet IP. Now I use 192.168.2.4 static IP for my ethernet card, and 192.168.2.5 for the pokeys. Mask 255.255.255.0 and getaway 192.168.2.254
And a tip.. If your spindle is unable to reach full RPM you have to install a small 1Kohm resistor in parallel with the 10V pokeys output.

3

PoKeys / Re: Setting error inputs

« on: February 16, 2020, 08:36:49 AM »

Hello exflueger
I will take some photos asap. But tell me first... do you use the usb or the ethernet connection?

4

PoKeys / Re: Setting error inputs

« on: October 06, 2019, 07:27:14 AM »

Hello again Fane

Thank you for your response.
After I saw your initial post here, I activated the OEM Trig#1 in both the pokeys plugin and Mach3 but it didn't work.
Then I added in your configuration, a brain script for trig#1 which gave false alarms and finally I set in pokeys #1 for X, #2 for Y, and #3 for Z and I made 3 brains accordingly.

Again thank you a lot for help

5

PoKeys / Re: Setting error inputs

« on: October 04, 2019, 06:13:28 AM »

Finally I found a solution through the brains

6

PoKeys / Re: Setting error inputs

« on: October 03, 2019, 05:24:07 AM »

Hi All,

OK, it's now resolved.
I have defined an OEM 1003 (stop) button, now I stop all if I have an error on an engine.
I use Closed Loop  Hybrid Servo Step Driver.

Greetings Fane.

Sorry for bringing this matter back up after this much time, but I would like to ask how you managed to connect the input OEM trigger#1 to the OEM 1003 button.

Looking forward to your response and thank you in advance.