Guest
Show Posts
1
Galil / One DMC-4080 with two CNC machines
« on: September 24, 2019, 06:26:24 AM »
Hi.
I have two equal CNC machines with built in +-10V amplifiers. They are 3 axis with dual X axis.
If I don't run them at the same time, can I use one Galil to control both?
Can I name the axis of the second machine something else than XYZ and change the axis names in G-Code, to have only one machine run even though all amplifiers are powered?
Regards
I have two equal CNC machines with built in +-10V amplifiers. They are 3 axis with dual X axis.
If I don't run them at the same time, can I use one Galil to control both?
Can I name the axis of the second machine something else than XYZ and change the axis names in G-Code, to have only one machine run even though all amplifiers are powered?
Regards