Messages

1

General Mach Discussion / Re: STEPCRAFT Plugin

« on: September 22, 2019, 08:12:11 AM »

You have right!
From Stoney the answer  was that they have support but only for the machines bought from them!
Whatever!
I will tray to make a copy set-up from UCCNC but I thought there are someone on  the forum which is using stepcraft with UC100 and Mach3 and can help me!

2

General Mach Discussion / Re: STEPCRAFT Plugin

« on: September 19, 2019, 04:10:36 PM »

Hi,
maybe I did not put the right question! Is more about Mach 3 profile (I said plugin) for Laser engraveing, for 3d printer extruder and for 3d touchprobe of stepcraft.

Also I wrote to stoney but now answer.

3

General Mach Discussion / STEPCRAFT Plugin

« on: September 18, 2019, 03:55:17 PM »

Hi evryone,
I have a stepcraft 420 router with diffrent application (printer extruder, milling, touchprobe and laser)
I am using UC100 controler and Mach3 as software but unfortunatly I did not find andy pligins for these application! I know that there are  (Stone.. from UK has -they are selling Mach3 with UC100 and stepcraft) but unfortunatly only in UK.)

How can I have this pligin to use stepcraft at fully potential!

Thank you