Messages

1

Mach4 General Discussion / Re: Input/Output PIN Mapping not being saved

« on: September 09, 2019, 04:46:32 PM »

Unfortunately it does not seem to make  difference in which order the table or computer is turned off, I have checked we only have the single profile installed and even re-installed Mach4 today and still getting the same behaviour any ideas?

Thanks

Adam

2

Mach4 General Discussion / Re: Input/Output PIN Mapping not being saved

« on: September 08, 2019, 06:16:08 AM »

Thank you, will try both suggestions when back in the workshop tomorrow.

3

Mach4 General Discussion / Re: Input/Output PIN Mapping not being saved

« on: September 07, 2019, 04:29:37 PM »

Sorry for the confusion, I am mapping pins in the UC300 plugin as per the attached screenshot. These are persistent and do not change.

The control configuration under inputs I am mapping the input as per the second screenshot but these are settings that are blank on restarting the application. Only the user description is kept.

Thanks

Adam

4

Mach4 General Discussion / Re: Input/Output PIN Mapping not being saved

« on: September 07, 2019, 03:22:21 PM »

I can only assign Outputs in the control plugin there is no mapping for inputs. The plugin changes are persistent but it seems like the pin mapping in Mach4 is not being flushed to the ini file in that case. I have check none of the are ready only, so not sure what else to do?

Thanks

Adam

5

Mach4 General Discussion / Re: Input/Output PIN Mapping not being saved

« on: September 07, 2019, 02:50:41 PM »

Yes there are outputs defined in the UC plugin which is fine and all works ok. However I need to map the input pins in Mach4 for limit/homing etc. All works as it should but is not saved when I exit the Mach4 application. Just need to know how to make my changes persistent across application restarts.

6

Mach4 General Discussion / Input/Output PIN Mapping not being saved

« on: September 07, 2019, 08:07:43 AM »

Hi,

We have Mach4 running with a UC300-ETH motion controller and every time I restart the Mach4 application I have to setup the Port/PIN mapping again as it does not get saved. Any ideas where to look to resolve the issue as it is driving me mad!

Thanks

Adam