Messages

1

General Mach Discussion / Re: mach3 with 5 axis machining problem

« on: September 04, 2019, 10:03:02 PM »

thanks a lot
I am trying.
May be the Acceleration and Velocity of C axis and X axis and Y axis is too much different.

thanks again

2

General Mach Discussion / Re: mach3 with 5 axis machining problem

« on: September 04, 2019, 05:51:51 AM »

thank you Tweakie
Yes, Use G61 Exact stop check do solve my problem.
But G61 also make the machine work one not so smoothly.
I think I have to try to find the more solutions.

3

General Mach Discussion / Re: mach3 with 5 axis machining problem

« on: September 03, 2019, 01:51:46 PM »

I have tried Ver. 3.043.062
it is the same nothing changed.
any one knows why it is happened?

4

General Mach Discussion / mach3 with 5 axis machining problem

« on: September 01, 2019, 03:41:38 AM »

my mach3 ver. is 3.043.066 OP. is windows XP
and I got FRO% problem

Like the photo which i attached.
The letter B I have to turn down the FRO% to 30% then I got the right result and the higher FRO% the B is more twist on the end of straight line.

how could I solve this problem?
Is changing to ver. 3.043.062 helped?