Hello Guest it is March 28, 2024, 06:38:57 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - nigata

Pages: 1
1
I have setup my board like in your picture. I had tried to change the pin number in all of them... Nothing seems to work. It came with a manual but its not for this board...

I will keep trying, maybe i will find some solution... Because for now... Paying 200 euros for a good motion card its not an option unfortunately 😔

2
The only problem i have is the output signals. I cant make them work. Maybe its software problem? I dont know. Maybe i miss some part? Everything else runs good.

3
Hello everybody.

I am quite new to the CNC world and i have a problem with my setup on my plasma machine.

I use a chinese RnR motion usb Card with Mach3



I had managed to setup motors and all,

the problem i have is that i cant manage to get the torch to open. I use a simple relay. I had setup the output but nothing changes and the card doesn't give any indication it gives any signal.

in the diagnostics output1 has a red led when i turn on it manualy

I dont use a THC.

any suggestions?

Pages: 1