Hello Guest it is March 28, 2024, 08:31:22 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - sluis05

Pages: 1
1
hello, I am running mach 4 hobby with the uc100 motion controller trying to run THC in manual for oxy acetylene torch. On our previous mach 3 system/computer THC was:
THC on port 2 Pin 8
THC up port 2 pin 7
THC down port 2 Pin 6
With mach 4 and uc100 it is only giving me the options port 1, pin 10-15
I loaded a simple g code file to check to see if it was working and tried to adjust torch height while running the code. The up and down controls for THC are actually moving my Y axis. How can I fix this?
thank you in advance. I am new to the cnc world so please bear with me.

Pages: 1